Resorte - Create phone / book stands to 3D print in vase mode

01Container

Thickness

Widthoptional

Heightoptional

Angle

Measured from the table.

Stand width

Becomes the print height in vase mode.

Base height

Lifts the holder off the table.

Base depth

Auto centers the base under the container, for the most balance.

Back height

Auto leaves 61.8% of the container height resting flat on the back.

Lip height

How far the front lip rises above the pocket floor.

Corner rounding

Smooths the back and bottom corners with continuous curvature.

Advanced

Pocket tolerance

Extra room added to the thickness.

Nozzle width

Set the slicer's extrusion width to match. Lips and floors are two lines thick.

resorte_triangle_thickness-8.8_width-71.9_angle-60.stl

How to print

Drop the STL in your slicer.
Check the print height is 71.9 mm. The stand width becomes the height in vase mode.
Turn on vase mode. In PrusaSlicer: Print Settings → Layers and perimeters → Spiral vase.
Set the extrusion width to 0.6 mm. Lips and floors are drawn 1.2 mm thick so the path going out and back fuses into one solid wall.
Removing the bottom layers leaves the hollow look.

AProfile

BModeldrag to orbit